Operation points and maintenance of high-speed pick and place machine

High-speed pick and place machine operation points and maintenance
The high-speed pick and place machine is only suitable for CHIP components (ie, resistors and capacitors) and small three-tubes. The pursuit of mounting speed, the mounting speed is much faster. The range of high-speed pick and place machine components that can be mounted is usually relatively small. The components that can be mounted are generally from 0.4mm X 0.2mm ~ 24mm X 24mm, and the height of the components is generally 6.5mm. Some high-speed placement heads can only mount components as much as 5mm X 5mm, and the height of the components is only as much as 3mm. Mounting a large component device will cause the mounting speed to decrease. Because the high-speed pick and place machine is extremely fast, the operation of the high-speed pick and place machine must understand its operating points and the maintenance of the high-speed pick and place machine
One, high-speed pick and place machine operation points
1. Understand common signs of high-speed pick and place machine
As we all know, many machines and equipment have some specific signs for the operators to learn before they are used, and the high-speed pick and place machine is no exception. Therefore, in the operation of high-speed pick and place machine, it is necessary to fully understand the meaning and function of these signs, so as to play a warning role, so that the high-speed pick and place machine can be used and operated more safely.
2. Do a super high-speed pick and place machine boot inspection
The power-on inspection mainly includes: confirm whether the air pressure of the patch is in the normal range, whether there are any sundries inside the machine, whether the patch is installed in place… etc. Although these are minor problems, they are all very important. As long as these are done well, the long-term normal use of the high-speed pick and place machine can be ensured.
3. Set up and install the PCB positioning device
First, set the PCB positioning method according to the operating rules. Generally, there are two methods of pin positioning and edge positioning. Moreover, when using pin positioning, you should install and adjust the position of the positioning pin according to the position of the PCB positioning hole L. Make the positioning pin exactly in the middle of the positioning hole of the PCB to make the PCB go up and down freely. When edge positioning is used, the position of the stopper and the block must be adjusted according to the outline size of the PCB.